The vinyl wallpaper adhesive is designed for vinyl, washable, chip, porous wallpapers, and polystyrene boards. It is easy to mix, a layer type product that chemically contains anti-mold additives. This adhesive slides very well. It is suitable for the initial coating of plastered walls before wallpapering.

Usage Instructions:

1. Surface Preparation. The surface to be glued must be clean and dry. The part of the surface that is most susceptible to mold should be washed with a fungicidal solution. For the initial coating of the wall with adhesive before wallpapering, mix the contents of the packet in 9 liters of cold water. Before wallpapering, allow the adhesive-coated surface to dry completely.
2. Mixing. Pour the contents of the package into cold water and mix quickly until the mixture is completely combined. Let it sit for 3 minutes and then mix thoroughly again. After the second mixing, the adhesive is ready for use.
3. Gluing. When gluing wallpaper, follow the manufacturer's instructions. Soak the paper until it becomes soft. Pay special attention to applying adhesive on the edges of the wallpaper, but do not apply too much. Be careful not to let adhesive spill onto the front of the wallpaper, but if it happens, clean adhesive stains with a damp sponge.

Health and Safety Information:

S2 Keep out of reach of children. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S28 In case of contact with skin, rinse immediately with plenty of water.

Consistency: in flakes

Validity Period: indefinite

Vinyl and Washable Wallpapers: Cold water per package - 6 liters. Covered area m²/rolls - 40 m²/8 rolls.

Porous Vinyl Wallpapers: Cold water per package - 4.5 liters. Covered area m²/rolls - 20 - 25 m²/4 - 5 rolls.

Special Relief Wallpapers: Cold water per package - 4 liters. Covered area m²/rolls - 3.5 - 4 rolls.

Polystyrene Boards: Cold water per package - 4.5 liters. Covered area m²/rolls - 48 m².